Furrion net-zero FSPP95SA-BL Manuel D'instructions page 13

Operation
Digital Tube Display - The reference of LED for parameter and setting value is shown in the table:
LED1 Item
1 Battery type
2 Low voltage disconnect voltage
+ Low Voltage Reconnect Voltage = Low Voltage Disconnect Voltage +0.5V/12V (x2/24V).
# Radix point of LED segment display indicates the value added "10", for example 0. = 10, 4. = 14.
LED Code:
Code
E1 Over discharged
E2 Under voltage
The radix point of LED1
lighting up indicates that
load is ON. Oppositely, load
is OFF.
NOTE: Only the Load over load and the Load short circuit can be cleared by pressing the button.
LED2
Default Range
1 1-3
5 0-4
+ #
Detail
If the fault and working state on the left appear, the
corresponding code will be displayed. If several states
occur at the same time, these codes will be displayed
circularly (at 1 second intervals). If only one state
occurs, the code flashes once per second. You can
still enter the setting mode and set parameters even
if an error shows.
Load state (radix point) will conceal during fault
displaying and parameter setting
Value
1: Sealed
2: Gel
3: Flooded
10.6V-12.0V Unit value
= 0.1V (x2/24V)
12