Dell Networking S6010-ON Guide Demarrage Rapide page 86

All manuals and user guides at all-guides.com
Installing a 1U Front-Rack
You must configure the rails that are attached to the system.
1. Attach the switch rails (inner chassis members) to the S6010–ON system
( items 1 and 2 in the following figure). Item 3 shows the detail for the
front standoff with the locking tab.
Figure 8. Attaching the Switch Rails
2. After you have installed both switch rails, line them up on the previously
mounted Ready-Rails and slide the switch in ( item 1 in the following
figure) until it is flush with front of rack. About 3 inches before you fully
insert your system, the rail locking feature (items 2 and 3) engages to
keep the switch from inadvertently sliding out of the rack and falling.
16