SAS RM-MT330-2 Manuel D'utilisation page 61

Sparks at
the spark
plug
electrodes
Sparks at
the spark
plug
Air filter
Fuel filter
Fuel vent
The engine
turns, but
Spark plug
stalls or
does not
accelerate Carburetor
correctly
Cooling
system
Spark
suppressor
GB
There is no spark
There is no spark
Dirty air filter
Dirty fuel filter
Blocked fuel vent
Dirty or worn
spark plug
Bad adjustment
Excessive
Plate cracked,
contaminated or
perforated
30
Switch in off
position
Electrical problem
Locked switch
Bad spacing of the
electrodes
Electrodes
contaminated
Electrodes
contaminated with
fuel
Defective spark
plug
Fair wear and tear
Dirt or residue in
the fuel
Dirt or residue in
the fuel
Fair wear and tear
Vibration
Prolonged use in
dirty or dusty
places
Fair wear and tear
Set the switch to the ON
position (Run)
Ask your distributor for
advice
Adjust the gap to 0,6-0,7
mm
Clean or replace
Clean or replace
Replace the spark plug
Clean or replace
Replace
Clean or replace
Clean, adjust or replace
Adjust
Clean
Replace