Orbegozo FH 5041 Manuel D'instructions page 14

FH 5041 – FH 5141
GENERAL DESCRIPTION
A. Air inlet grille
B. Air outlet grille
C. Selector switch
D. Thermostat knob
E. Control lamp
INSTRUCTIONS FOR USE
The selector switch and the thermostat knob enable you to
select the following functions:
Selector switch:
Ο : OFF. Both the fan and the two heating elements are switched off
: "Cool air". Only the fan is switched on
•
: "Warm air for gradual heating-up. ECO position (1000 W): the fan andone of the heating leements are
switched on.
••
: "Hot air" for quick heating-up. Full power (2000 W): the fan and the two heating elements are switched
on.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
•
position or position
below the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower temperature
setting.
You may adjust the thermostat during use.
Control lamp:
The control lamp indicates the operation if any st
 The control lamp shines so long, since the thermostat switches off the device with reaching of the
opposed ambient temperature and begins again if the thermostat again turns on the device.
 If the steps switch turned on position 0 or the device by the electricity mains is taken, the control lamp
goes out.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot.
MAINTENANCE
Cleaning.
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
- Set the selector switch to position 0 to switch off. Remove the mains plug from the wall socket. Wait for
the heater to cool down sufficiently.
••
the heater will automatically switch on as soon as the room temperature falls
ep is turned on in combination with the thermostat switch.
14