MSI FUZION Serie Mode D'emploi page 50

▍
MS-7582 Manboard
▶ Adjust PCI-E Frequency (MHz)
Ths field allows you to select the PCIE frequency (n MHz).
▶ Auto Dsable PCI Frequency
When set to [Enabled], the system wll remove (turn off) clocks from empty PCI slots to
mnmze the electromagnetc nterference (EMI).
▶ VDroop Control
Ths s used to prevent a large number voltage dropng when system n hgh loadng
status.
▶ CPU Voltage(V)/ CPU VTT (V)/ CPU PLL Voltage(V)/ DRAM Voltage (V)/ DDR_
VREF_CA_A (V)/ / DDR_VREF_CA_B (V)/ DDR_VREF_DA_A (V)/ DDR_VREF_DA_B
(V)/ PCH 1.05V (V)
These tems are used to adjust the voltage of CPU, Memory and chpset.
▶ Spread Spectrum
When the manboard's clock generator pulses, the extreme values (spkes) of the pulses
create EMI (Electromagnetc Interference). The Spread Spectrum functon reduces the
EMI generated by modulatng the pulses so that the spkes of the pulses are reduced
to flatter curves.
Important
• If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
• The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
•
jtter can ntroduce a temporary boost n clock speed whch may just cause your
overclocked processor to lock up.
En-40