Dreame VWV7 Manuel D'utilisation page 16

Care & Maintenance
EN
Tips:
1. Make sure the vacuum is unplugged in and not working.
2. Parts need to be replaced if necessary. Please use the parts designated by the original
factory to avoid damage to the product due to unsuitability.
3. If the vacuum is not used for an extended period, fully charge it, unplug its charger,
and store it in a cool, low-humidity environment away from direct sunlight. To avoid
over-discharge of the battery, recharge the vacuum at least once every 3 months.
One-Click Self-Cleaning
* The self-cleaning function can be enabled only when the vacuum is charged and the
battery level is more than 10%.
1. Place the vacuum upright on the charging base after designated cleanups and make
sure the clean water tank is full.
2. Press the self-cleaning button on the top of the handle briefly, the self-cleaning
indicator lights up on the screen and the self-cleaning starts.
3. The vacuum will continue to recharge after the self-cleaning is finished.
Note:
• If the deep self-cleaning is needed, press and hold the
self-cleaning function. Please fill the clean water tank and empty the dirty water tank
before activation, and this function can be activated only when the vacuum is charged
and the battery level is more than 30%.
• After self-cleaning is completed, clean the dirty water tank in time. If there are residual
stains on the base, please clean up the base in time.
12
button to activate the deep