Ryobi PCL235 Manuel D'utilisation page 7

INSTALLING / REMOVING BATTERY PACK
See Figure 3, page 9.
„ Lock the switch trigger.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap in place and battery pack is secured before begin-
ning operation.
„ Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
INSTALLING / REMOVING BITS
See Figure 4, page 9.
To install bits:
„ Remove the battery pack from the tool.
„ Slide the collet forward and hold in position.
„ Insert bit straight into collet.
NOTE: If the bit does not insert easily into the collet, pull
the collet forward and reinsert the bit.
„ Slide the collet back slowly and release.
NOTE: Use only impact quality bits with a locking groove.
WARNING:
Make sure the bit is secured in the collet before using
the impact driver. Failure to do so could cause serious
personal injury.
To remove bits:
„ Remove the battery pack from the tool.
„ Slide the collet forward and hold in position.
„ Pull the bit straight out of the collet.
NOTE: MAINTENANCE INSTRUCTIONS BEGIN ON PAGE 8
FOLLOWING FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ILLUSTRATIONS START ON PAGE 9.
7 - English
LED LIGHT
See Figure 5, page 9.
The LED light located on the front of the tool base illuminates
when the switch trigger is depressed.
The LED light illuminates only when there is a charged bat-
tery pack in the tool.
USING THE IMPACT DRIVER
See Figures 6 - 7, page 9.
NOTICE:
The impact driver is not designed to be used as a drill.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a "live" wire will
make exposed metal parts of the tool "live" and possibly
shock the operator. If you must drive a screw where hid-
den wire may be present, always hold tool by insulated
gripping surfaces (handle) when performing the operation
to prevent a shock to the operator.
„ Check the direction of rotation selector for the correct
setting (forward or reverse).
„ Hold the impact driver with one hand.
„ Place the bit on the screw head, bolt head, or nut and
slowly depress the switch trigger. Start the bit slowly for
more control.
„ As the screw, bolt, or nut is driven, impacting will begin.
ELECTRIC BRAKE
The electric brake will stop the bit rotation after the operator
releases the switch trigger.