Publicité
Les langues disponibles
Les langues disponibles
4.4 SWITCHING ON AND OFF
Before engage the ON/OFF switch button, check that the grinding disc is properly fitted and
run smoothly, the outer flange is well tightened.
The grinder disc continues to rotate after the tool is switched off!
4) Connection to power supply
a.
Make sure the on/off switch (2) is not pressed.
b.
Connect the plug with a suitable power socket.
WARNING! Check the voltage! The voltage must comply with the
information on the rating lab
c.
Your product is now ready to be used.
5) ON: Move the middle part to the right, then push forward
the switch button.
6) OFF: To stop the operation, release the switch button.
4.5 OPERATON MODES
Grinding
Hold the handle and auxiliary handle (6) firmly and switch
on. Avoid blocking the ventilation slots with your hand, as
this may cause the grinder to overheat. Let the disc reach
full speed. Apply the grinder to the work piece. Make sure
the work piece fixed well not moved during the working.
Maximum effect is achieved when the grinder is held at an
angle of 15-30°in relation to the work piece. Move the
grinder gently along the work piece. Give the grinder time to
work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks can occur in the
motor compartment during use. This is normal and does not mean the grinder is defective. Switch off the
grinder after using.
Ensure that the product is in good condition and well maintained. The ambient temperature for product to
use is -5
C to 45
C
o
o
FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS
Flange arrangements when using a depressed centre or straight grinding wheel.
1 Clamping flange
2 Flange nut
el!
22
Publicité
