Auchan MAM720 Instructions page 21

4. OPERATION
Before the first use：
Check if the package is complete and not damaged.

If some parts are missed or damaged, please do not use the tool and bring it back to your dealer.

WARNING: The tool must be always switched off and unplugged before assembly!
4.1 FITTING THE AUXILIARY HANDLE
The auxiliary handle (6) can be attached to the angle grinder in 3 different positions: left and right and top of
head.
4.2 MOUNTING AND REMOVING THE GUARD
Never use the machine without guard!
Place the machine with the spindle upwards on a table

Place the guard over the spindle. (Fig.2,Fig.3)

Move the carter of protection to correct position.(Fig.4)

Tighten the nut firmly.(Fig.5)

To remove the guard, proceed in reverse order.

Fig.2
4.3 REPLACING THE GRINDING DISC
NOTE: The tool is delivered without grinding disc; see you dealer to buy recommended disc with this tool.
1) Depress and hold down the spindle lock button (1) to secure the spindle.
2) Turn the shaft until it locks.
3) Remove the outer flange(a) and backing flange(b) by using the two-hole spanner provided.
4) Fit the desired disc on the spindle and replace the outer flange and backing flange.
5) Release the spindle lock.
Important! Only ever press the spindle lock when the motor and grinding spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel !
1
Fig.3
Fig.6
Fig.4
21
Fig.5
Disc