emerio HO-132338.1 Mode D'emploi page 4

20. Ensure that the mains cable is not hung over sharp edges and keep it away from hot objects and open
flames.
21. Do not immerse the appliance or the mains plug in water or other liquids. There is danger to life due to
electric shock!
22. To remove the plug from the plug socket, pull the plug. Do not pull the power cord.
23. Do not touch the appliance if it falls into water. Remove the plug from its socket, turn off the appliance
and send it to an authorized service center for repair.
24. Do not plug or unplug the appliance from the electrical outlet with a wet hand.
25. Never attempt to open the housing of the appliance, or to repair the appliance yourself. This could cause
electric shock.
26. Never leave the appliance unattended during use.
27. This appliance is not designed for commercial use.
28. Do not use the appliance for other than intended use.
29. Do not wind the cord around the appliance and do not bend it.
30. The oil heater may only be used in the upright position.
31. The unit must be positioned away from flammable or easily deformable objects during use.
32. Place the oil heater on the floor at least 100 cm away from the wall and any other objects, such as
furniture, curtains or plants.
33. The surface temperature of the appliance is high; do not touch it, only at the handle.
34. This heating device is not suitable for assembling in vehicles and machines.
35. Regarding the information for the assembly of base support, please refer to the below paragraph of the
manual.
36. The heater should not be used in a room, of which the floor area is less than 5 M
DESCRIPTION
1. Heating elements
2. Handle
3. Thermostat knob
4. Heat select knob
5. Indicator light
6. Wheel
7. Wheel mounting plate
8. Cord storage
9. Timer
10. 3-in-1 switch ("O": power off // "
operate with timer function // "I":
operate without timer function)
WHEELS ASSEMBLY
WARNING: Do not operate without feet attached. Do operate the heater only in upright position.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall.
2. Install four wheels to 2 pieces of wheel mounting plates.
Screw off spherical nut from the wheel, align the shaft to the hole of the wheel mounting plate, insert in,
and screw back the spherical nut.
3. Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to the U-facing flange
":
- 3 -
2
.