Publicité
Les langues disponibles
Les langues disponibles
A
Installation (extraction outdoors)
CAUTION:
Follow the warnings given in the instructions with regard
to using the appliance in the mode that extracts air into the
room.
Fixing to a wall
1. Drill 2 holes, 8 mm in diameter, in a suitable location, centring them in relation to the hole at
the back of the extractor fan. (These two holes must be horizontally aligned) (Figure
2. Insert 2 wall plugs and two 4x30 mm headless screws (The screws must not be screwed in
completely; 2-3 mm must be left protruding in order to be able to hang the extractor on them).
3. Lift up the extractor and hang it on the wall.
4. Mark and drill 2 holes, 8 mm in diameter, and insert 2 safety screws with 2 wall plugs and two
4x30 mm headless screws.
Using the appliance
450mm
4
6
EN
4
)
Publicité
