Publicité
Les langues disponibles
Les langues disponibles
packaging elements must be disposed of according to their raw material (see the symbol stamped
on each one) and according to the provisions of their municipality.
packaging with low weight (es: packing tape) are unmarked as are its small size packing materials,
the protective film of surfaces: therefore you have to follow the procedures for the disposal in force
in your municipality.
removed before using the appliance.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded. In the event of incompatibility between the
plug point and the plug of the appliance, have the plug replaced with
professionally qualified personnel, who will make sure that the section of the wires of the outlet is
suitable for the power drawn by the appliance. In general, the use of adapters or extension cords
is not recommended; if their use is necessary, they must conform to existing safety standards and
their current capacity (amperes) must not be less than the maximum of the appliance.
• Before each use, check that the equipment is in good condition, that the power cord is not
damaged: if in doubt consult a qualified professional.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Keep the appliance away from:
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it falling in
-
(minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille; make
-
sure that the front is free of floating materials (dust, etc.).
• The appliance must not be used in dusty environments or in the presence of floating materials or
used in a room where there is a fire risk.
• Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined surface
(the appliance could fall over).
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base and support and protection grid. If in doubt, have the appliance checked or assembled by a
qualified professional person. For assembly, refer to below figure.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Please put the appliance on a secure surface:
Note: any stickers or advertising material applied to the grille must be
10/24
The secondary elements of the
suitable one by
Publicité
