Switching ON/OFF (Fig. F)
WARNING:
product firmly when switching on.
CAUTION:
self or bystanders.
•
To turn the blower ON, ensure the speed lock lever
in the off position and depress the trigger switch
•
To lock the blower ON, pull back on the speed lock lever
2
, as shown in fig. H. The blower runs at higher speeds
as the lever is moved further. The speed lock lever can
also be pulled back to start the blower without needing
to first depress the trigger switch.
•
To turn the blower OFF, release the trigger switch
or push forward on the speed lock lever and return it to
its off position.
fig. H
2
Use (Fig. G)
CAUTION:
self or bystanders.
CAUTION:
hearing protection. Wear a filter mask if the operation
is dusty. Use of gloves, long pants and substantial
footwear is recommended. Keep long hair and loose
clothing away from openings and moving parts.
•
Install the battery pack
•
Hold the blow tube approximately 7 inches (180 mm)
above the ground, turn the blower ON and using a
sweeping motion from side to side, advance slowly
keeping the accumulated debris/leaves in front of you
as shown in Fig. G.
Use both hands to grip the
Do not point unit discharge at
1
Do not point unit discharge at
Always wear safety glasses and
10
into the battery housing.
Fig. G
2
is
1
.
MAINTENANCE
1
and
WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Cleaning
WARNING:
all air vents with clean, dry air at least once a week.
To minimize the risk of eye injury, always wear ANSI
Z87.1 approved eye protection when performing this
procedure.
WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories
WARNING:
those offered by D
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
D
WALT recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
To reduce the risk of
Blow dirt and dust out of
Never use solvents or other
Since accessories, other than
WALT, have not been tested with
e
WALT Industrial
e
English
9