Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Proper hand position requires one hand on the main
handle
4
.
fig. F
Switching On (Fig. A, F, G)
CAUTION: Do not point unit discharge at self or
bystanders.
CAUTION: Always wear safety glasses. Wear a filter
mask if the operation is dusty. Use of gloves, long
pants and substantial footwear is recommended. Keep
long hair and loose clothing away from openings and
moving parts.
To turn the blower on, depress the trigger switch
To lock the blower on,
pull back on the speed
lock lever
2
, as
shown in figure G. The
blower runs at higher
speeds as the lever is
moved further. The
speed lock lever can
also be pulled back to start the blower without needing to
first depress the trigger switch.
•
Hold the blower with one hand as shown in figure F and
sweep from side to side with the tube
above the hard surface. Slowly advance keeping the
accumulated pile of debris in front of you.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and unplug before making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
4
fig. G
several inches
4
Accessories
WARNING: DO NOT use the blower with any type
of accessory or attachment. Such usage might be
hazardous.
WARNING: Since accessories, other than those
offered by D
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1–800–4-D
www.dewalt.com.
Repairs
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D
.
1
or a D
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
WALT, have not been tested with this
e
WALT (1–800–433–9258) or visit our website:
e
WALT factory service center
e
WALT authorized service center. Always use
e
English
WALT
e
WALT Industrial
e
5
Publicité
Table des Matières
