Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS:
1. Carefully unpack the fixture. Lay out all parts on a clean surface.
2. Feed the Wires (#4) of one Arm Assembly (#3) in through one side hole of the
Wire Housing (#5) and through its top opening. Slide the Star Washer (#41)
and Hex Nut (#6) onto the Wires (#4). Secure each Arm Assembly (#3) to the
Wire Housing (#5) using an Hex Nut (#6) and Star Washer (#41), as shown,
using the provided Wrench (#26). (Fig. 1)
3. Unravel the two Extension Wires (#7 & #8). Feed the two Extension Wires
(#7 & #8) into the bottom opening of the Wire Housing (#5) through to the top
opening. (Fig. 2)
4. Using the provided Wire Nuts (#9), make wire connections between the White
Extension Wire (#7) and the White Arm Assembly Wires (#10) and between
the Black Extension Wire (#8) and the Black Arm Assembly Wires (#11), as
shown. Wrap each wire connection with 2" of electrical tape. (Fig. 2)
5. Slide the Top Cover (#12) onto the Threaded Pipe (#13) and onto the Wire
Housing (#5). Thread the Cover Finial (#14) onto the Threaded Pipe (#13) to
secure the Top Cover (#12). (Fig. 2)
6. Unravel and extend the Fixture Ground Wire (#15) of the Wire Housing (#5).
(Fig. 2)
7. Attach Pole (#2) to the Base (#16) using the provided Pole Screws (#17) and
Star Washers (#40). (Fig. 3)
8. Thread Pole (#1) onto Pole (#2). (Fig. 4)
9. Feed the Wires (#7, #8 & #15) of the Three-Head Lantern Assembly (#19)
through the entire Pole/Base Assembly (#20) to the bottom opening. Screw
the Pole/Base Assembly (#20) into the Wire Housing (#5) of the Three-Head
Lantern Assembly (#19). (Fig. 5 & 6)
Page 5
Publicité
