Télécharger Imprimer la page

KitchenAid KUDS01DL Guide D'utilisation Et D'entretien page 15

Masquer les pouces Voir aussi pour KUDS01DL:

Publicité

Les langues disponibles

Les langues disponibles

Use this cycle for china and
crystal. This cycle uses a
light wash and gentle dry.
During the heated dry, the
heating element cycles on
and off.
Main
Rinse
Purger
Final
Wash
Heated
Rinse
Use main
detergent
dispenser section.
Soil
Rinse
Dry
Time
Water
Level
(min)
Usage
Sensed
(gal/L)
79*
7,1-8,6/
Heavy
120°F
135°F
cycled
27-33
(49°0)
(57°0)
71"
5,9/
Light
120°F
135°F
cycled
22,3
(49°0)
(57°0)
Anytime during a cycle, press the Cancel pad.
The display shows
Use this cycle for a quick wash
_]
and light dry to clean up
cookware prior to entertaining.
The sensor adds water and
Use main
time to the cycle, if needed, for
detergent
maximum cleaning. This cycle
dispenser
uses a shortened dry time.
section.
Towel drying may be needed.
Water
Rinse
Main
Rinse
Final
Dry
Time
Water
Temp
Wash
Heated
(rain)
Usage
Sensed
Rinse
(gal/L)
Hot
44*
5,2-6.5/
20-25
Cold
48*
7,1-8.2/
27-31
Use this rinse cycle for
_}_
Q_ _
rinsing dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent
with
this cycle.
Soil
Pre-
Rinse
Main
Rinse
Final
Dry
Time
Water
Level
Wash
Wash
Heated
(rain)
Usage
Sensed
Rinse
(gal/L)
10
1.8/7
Your dishwasher
starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher
does not need draining, the light turns
off, Select a new cycle and options.
To stop the drain
You can press the Cancel pad again to stop the drain
immediately. Remember to drain the dishwasher before starting a
new cycle.
To clear the indicators
Press the Cancel pad before starting the dishwasher to clear all
options and cycles.
During
the first minute
of a cycle
1. Open the doo£
2. Press a new cycle and/or options.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
4. Close the door. The dishwasher resumes the new cycle
and/or option after a 5-second pause.
After the first minute of a cycle
1. Press the Cancel pad.
t
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
NOTES:
The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
The display shows
Your dishwasher starts a 2-minute drain (if needed). Let
the dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Open the door.
3. Select a new cycle and/or options.
4. Check the detergent dispensers. They must be filled properly
for the new cycle.
5. Close the door.
6. Press the Start pad.
15

Publicité

loading