Eaton TRIPP LITE Serie Manuel Du Propriétaire page 9

3. Installation
5. Connect the patch cord connecting in front of module.
To remove the cable: the cable on left module should be pulled out on the left,
and the cable on the right module should be pulled out on the right.
To prevent the cable from bending, use the module cover and organize the
cables as shown in the image below.
If the module is on
the left, the left-most
cable should be
under the cover.
03-493-9347A1_revA.indb 9 03-493-9347A1_revA.indb 9
All the cabling should be under these two
covers to prevent the cable from being
damaged while being moved in and out.
If the module is on
the right, the right-
most cable should be
under the cover.
1/4/2024 10:48:22 AM 1/4/2024 10:48:22 AM
9