Attaching Handle - Delta 50-723 T2 Manuel D'utilisation

8. Place M6 hex socket head screw (23)
through hole of blower housing bracket and
thread into rear blower housing support
(Fig 9).
9. Tigten screw.
10. Repeat on other side.

ATTACHING HANDLE

1. Insert handle into both brackets on blower
housing (Fig 10).
2. Align holes in handle with top holes
in blower housing brackets.
3. Screw in M8 Phillips head self tapping
screw (21) on both sides (Fig 11).
4. Insert tube end cap into end of handle.
5. Be sure cap is seated (Fig 12).
6. Repeat on other side.
FIGURE 11
ASSEMBLY (continued)
11
FIGURE 9
FIGURE 10
FIGURE 12