Art SOLO MPA Manuel De L'utilisateur page 9

1 2
I/O INPUT
LEVEL
+4 dBu +4 dBu
Yorkville Sound
550 Granite Court
Pickering, Ontario
-10 dBV -10 dBV
Canada L1W 3Y8
BAL ANCED INPUT & OUTPUTS
Rear Panel
1. I/O Level Switch
+4dBu/-10dBV
The +4dBu/-10dBV switch is used to set the output level of the Solo MPA for the appropriate system levels. This feature
allows you to match 0 VU on the meters of the Solo MPA and your mixer or other equipment.
When depressed, 0 VU on the output meter corresponds to +4dBu on the outputs. In –10dBV mode, the output level
measures –10dBV.
2. Balanced Inputs
The Solo MPA's XLR connectors follow the AES standard of Pin 1 = Ground, Pin 2 = Hot (+), Pin 3 = Cold (-). The
Balanced inputs have an input impedance that is variable from 150 to 3K ohms via the front panel control. The Maximum
input level is +19dBu balanced and +17dBu unbalanced.
3. Balanced Outputs
The Solo MPA's flexible active balanced outputs are available on both ¼-inch and XLR connectors. They offer low impedance for
driving long cable runs and are intelligent enough to maintain the same output level whether it is balanced or unbalanced.
The Solo MPA's XLR connectors follow the AES standard of Pin 1= Ground, Pin 2= Hot (+), Pin 3= Cold (-). The
balanced ¼-inch phone jacks are typical Tip = Hot (+), Ring = Cold (-), Sleeve = Ground
Maximum output level is +27dBu balanced and +20dBu
4. IEC Power Connector
This is a fused variable voltage selectable IEC connector. The fuse drawer can be removed for fuse replacement and used
to set for the correct incoming voltage 100-120V or 220-240V. Rotate the fuse drawer so that the arrow from the drawer
lines up with the IEC block for the mains voltage.
3
A .R .T. SOLO MPA A .R .T. SOLO MPA
OUTPUT
CONNECTIONS XLR 1/4-INCH T.R.S.
PIN 1 = GROUND TIP
INPUT
PIN 2 = (+ + ) HOT RING = (-) COLD
OUTPUT
PIN 3 = (-) COLD SLEEVE = GROUND
unbalanced.
4
MODEL 111
SOLOMPA
WARNING - TO REDUCE THE A-ART-SOLO-MPA
RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE
SERIAL NUMBER
THIS EQUIPMENT TO RAIN
OR MOISTURE
= (+ + ) HOT
DESIGNED BY YORKVILLE SOUND
AVERTISSEMENT - POUR RÉDUIRE
TORONTO, CANADA
LE RISQUE D'INCENDIE OU
D'ÉLECTROCUTION, NE PAS Made in China
EXPOSER ET APPAREIL
À LA PLUIE OU À L'HUMIDITÉ
1v4
AC INPUT:
100-240V
50/60Hz 25W
FUSE:
T1.0A 250V
5