Captron CANEO 10 Serie Mode D'emploi Original page 10

fully understood the contents before installing or working with the
SENSORswitches.
series10 standard
A SENSORswitch
B Flat seal (fitted)
C Lock nut
D Connection
Stainless Steel
A SENSORswitch
B Flat seal (fitted)
C Lock nut
D Connection M12
E O-ring (only required for
snap-in assembly and can
be ordered separately)
Assembly
series10 assembly with lock nut
Requirements:
Mounting surface is level and clean (maximum unevenness in
mounting surface 0.1 mm).
The panel is between 1.0 mm and 9.5 mm thick.
► Disconnect the system from its voltage supply and secure it
against being switched on again.
► Set the desired position of the SENSORswitch and drill the hole
according to the drilling pattern.
► Insert the SENSORswitch (A) into the prepared hole and screw
the lock nut (C) on.