Dexter SD1600VX Traduction Des Instructions D'origine page 35

15. Troubleshooting
m WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Saw blade without pins
loosens after switching
off the engine
Motor does not start
Saw blades brake
Saw blade oscillates, not
aligned straightly.
GUARANTEE:
Thank you for investing in a ADEO power tool. These
products have been made to demanding, high-qual-
ity standards and are guaranteed for domestic use
against manufacturing faults for a period of 24 months
from the date of purchase.
This guarantee does not affect your statutory rights. In
case of any malfunction of your tool (failure, missing
part, etc.), please contact service.
Service address: ADEO's Service address: 135 RUE
SADI CARNOT CS00001, 59790 RONCHIN, FRANCE
Possible cause
Saw blade clamping screw (27/28) not
tightened enough
Mains fuse blown
Extension cable defective
Fine-wire fuse defective
Connection to the motor or switch not OK
Motor or switch faulty
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Holders not aligned
Remedy
Tighten the saw blade clamping screw
(27/28)
Check mains fuse
Replace the extension lead
Check the fine-wire fuse and, if
necessary, replace it with a fine-wire
fuse of the same type.
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders.
Bring the holders into the vertical posi-
tion and tighten the screws again.
Normal wear and tear, including accessory wear, is not
covered under guarantee. The product is guaranteed
for 24 months if used for normal demostic use. Any
guarantee is invalid if the product has been overload-
ed or subject to neglect, improper use or an attempted
repair other than by an authorized agent. Heavy-duty,
daily professional or hire usage are not guaranteed.
Due to continuous product improvement, we reserve
the right to change the product specification without
prior notice.
GB | 35