Publicité
Les langues disponibles
Les langues disponibles
Connection type Y
If the mains connection cable of this device is dam-
aged, it must be replaced by the manufacturer, their
service department or a similarly qualified person to
avoid dangers.
11. Transport
• Transport the electric tool by lifting it on the recesses
provided for this on the frame and the motor cover.
• Never use the protective devices for handling or
transport.
• Make sure that the exposed part of the saw blade
is covered during transport, e.g. by the protective
device.
12. Cleaning, maintenance and
ordering spare parts
m WARNING
Always switch the machine off and remove the mains
plug prior to all maintenance and cleaning work.
12.1 Cleaning
Keep protective devices, air vents and the motor hous-
ing as free of dust and dirt as possible. We recommend
cleaning the device directly after every use.
12.1.1 Exterior cleaning
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
• Do not use cleaning agents or solvents. These could
damage the plastic parts of the device.
• Make sure that no water can penetrate the device
interior.
12.1.2 Interior cleaning (fig. 15)
1.
Open the storage box (9).
2.
Remove the screw (34).
3.
Loosen the screw (33).
4.
Remove the cover (8).
5.
Blow out the device interior with low-pressure
compressed air.
6.
Attach the cover again (8).
7.
Fasten the screw (33).
8.
Insert the screw (34) again and tighten it.
9.
Close the storage box (9).
12.2 Maintenance
12.2.1 Bearings (fig. 1/item 10)
Lubricate the bearing points (10) of the deflection roll-
ers after approx. 25-30 operating hours at the latest
using high-quality machine grease.
12.2.2 Carbon brushes
If excessive sparks are generated, have an electrician
check the carbon brushes.
ATTENTION
The carbon brushes must only be replaced by an elec-
trician.
12.2.3 Mains cable
If the mains cable is pulled out, cut, or damaged in
some other form, then it should be replaced immedi-
ately.
12.2.4 Replacing the fine-wire fuse (Fig. 16)
If the fine-wire fuse (7) is defective, it must be replaced
with a fine-wire fuse of the same type 5 A/250 V
(ø 5 x 20 mm).
m WARNING
Do not bypass the fine-wire fuse (7)! Do not use fus-
es of any other type! This can lead to damage to the
device.
12.3 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Carbon brushes, saw blade, table inlay
* may not be included in the scope of supply!
12.4 Ordering spare parts
Please provide the following information when ordering
spare parts (via the service hotline):
• Device type
• Device article number (can be found on the packag-
ing or in the instructions)
GB | 33
Publicité
