Siemens MS6152M Mode D'emploi page 9

Overview
Please fold out the illustrated pages.
X Fig. A
1 Rotary knob and stop plate
Set slicing width (0 to 15 mm).
2 Start lock-out
Prevents the appliance from being
unintentionally switched on.
Press before switching on.
3 ON button
Fast and continuous operation.
4 Blade
5 Carriage
Guide the food which is to be sliced
against the blade.
6 Slide
Pos. 1 (slide on right)
= Lock the carriage in the end position
Pos. 2 (slide in centre)
= Carriage movable
Pos. 3 (slide on left)
= Remove carriage
7 Base
Supports the carriage.
8 "Sausage end" holder
Cuts residual pieces safely.
9 Cord store
Operation
Before using the appliance for the first time,
clean thoroughly.
Preparation
W Risk of electric shock!
Do not use the appliance near a sink filled
with water!
X Fig. A
■ Place the appliance on a smooth, clean
surface.
■ Pull out cable from the cord store 9 to
the required length:
1. Remove cable from the two clamping
slots.
2. Pull out/push in cable past the cover
to the required length.
3. Re-attach cable end.
■ Attach carriage 5 and "sausage end"
holder 8.
■ Use the rotary knob 1 to set the required
cutting width.
■ Insert the plug.
Switching the appliance ON/OFF
W Risk of injury from sharp blade!
Blade is very sharp. Keep hands clear of
the blade. After switching off, the drive
continues for a short time. After work, set
cutting width to 0.
X Fig. B
Instantaneous switching:
■ 1. Press the switch-on safety device and
hold down.
2. Then press ON button until the power
tool starts running.
3. Release the switch-on safety device
again.
■ To stop the appliance, release the ON
button.
X Fig. C
Continuous operation:
■ 1. Press the switch-on safety device and
hold down.
2. Then press the ON button.
3. Release both buttons.
4. Release the switch-on safety device
again.
■ To stop the appliance, press the ON
button again and release.
Slicing
X Fig. A
■ Place the food which is to be sliced on
the carriage and gently push against the
stop plate.
■ Slowly slide the food which is to be
sliced against the moving blade.
After using the appliance
■ Set the slicing width to 0.
■ Slide the carriage towards the blade into
the end position and lock with the slide
6 in Pos. 1.
English en
9