Publicité
Les langues disponibles
Les langues disponibles
REMEMBER
to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
6
Slip the yoke cover, trim ring and canopy onto the downrod.
(Fig. 3)
7
Slide the hanger ball onto the downrod, insert the cross pin
through the downrod and tighten. Tighten the set screw.
Lift ball/downrod/fan into hanger bracket opening.
8
NOTE: The tab opposite hanger bracket opening should fit
in slot on ball. (Fig. 4)
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the safety
cable from the fan. Loop the safety cable around the wood screw
that was just attached to ceiling joist. Feed the end of the cable
into the clamp and pull as much cable through as possible. Firmly
tighten screw in the clamp. Cut off excess cable and tighten the
wood screw to ceiling joist.
Cross pin
Hanger ball
Hook-up (5) wires
Downrod
Yoke cover
Top of
fan body
Fig. 3
Safety Cable Clamp
Safety Cable Loop
Wood Screw And Washer
Safety Cable
Fig. 4
Ground wire
Set screw
Canopy
Trim ring
Wood Ceiling Joist
©2024 Hinkley Lighting, Inc. | hinkley.com |
07
Publicité
