Hinkley 56 ALBA Manuel D'instructions page 12

INSTALLING THE LIGHT KIT AND GLASS SHADE
Fig. 1
CAUTION: To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before Installing
Light Kit.
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Pass the light wires through the center hole of the light
2
plate.
Place the key holes on the light plate over the 2 screws
3
previously loosened, turn the light plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the light plate located
4
on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
10 | hinkley.com
Wire connectors
Mounting hub
(bottom of motor)
Light plate
Screws
Fig. 2
5
6
5
7
8
Glass shade
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- White to white
- Black to black
Tuck connections neatly into light plate. Place the key holes
on the light kit over the 2 screws previously loosened, turn
the light kit until it locks in place at the narrow section of the
key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
Raise the glass shade against the LED light kit and turn
clockwise until snug, DO NOT OVERTIGHTEN.
Restore power and your light kit is ready for operation.
Light plate
Light kit
Screws