Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Your DC brushless motor is equipped with
an automatically learned type remote control.
There is no frequency switches on the
receiver or transmitter. The fan can start to
use once the pairing process is done.
Remove the panel from the transmitter and
then install one 2032 battery (included). You
need to use a screwdriver to open or close
the battery cover. To prevent damage to
transmitter, remove the battery if not use for
long periods of time (Fig. 1)
WARNING: Chemical Burn Hazard.
Keep batteries away from children.
This product contains a lithium button/coin
cell battery. If a new or used lithium button
/coin cell battery is swallowed or enters the
body, it can cause severe internal burns
and can lead to death in as little as 2 hours.
Always completely secure the battery
compartment. If the battery compartment
does not close securely, stop using the
product, remove the batteries, and keep it
away from children. IF you think batteries
might have been swallowed or placed inside
any part of the body, seek immediate medical
attention.
The batteries shall be disposed of properly,
including keeping them away from children;
Even used cells may cause injury.
1
button:
Press and release this button to turn
the light on / off.
2
button:
Press these buttons to dim or brighten
the lights to the desired level and
release.
3
button:
Press this button to set fan wind
direction up or down.
4
button:
Press these buttons to adjust fan
speeds up / down between speeds
1 and 6.
5
button:
Press and release this button to turn
the fan on / off.
Signal light (Fig. 2)
6
Pairing Process
NOTE: If installing/pairing more than
one fan in an area, the power must be
disconnected from all fans except the
one fan being paired.
NOTE: Fan must be fully installed
with the blades prior to pairing the
controls.
With the fan's power off, restore power to
the fan. Press and hold "
" button for about
5 seconds and release. If optional light kit is
installed, the light kit will flash three times
and the motor spin up for 10 seconds on low
speed. The fan has completed the pairing
process with the wall control and is ready
for use.
NOTE: A single fan can be controlled with as
many as 3 wall controls in one room. Every
control will need to repeat the pairing
process based on instructions above and
all controls must be within 30 feet of the fan.
Set screw
Fig. 1
Signal light
Fig. 2
HIRO Control System
©2024 Hinkley Lighting, Inc. | hinkley.com |
13
Publicité
