BGS technic 1101 Mode D'emploi page 4

COMPONENTS
USE
1. Place the two pressure plates between the contact surface of the brake caliper and the brake
caliper pistons.
2. Move the pressure plates apart until they rest on the piston and the contact surface of the brake
caliper, using the ratchet handle.
3. Check the correct alignment of the pressure plates; they must be parallel to the contact surface and
piston of the brake caliper.
4. Continue extending the pressure plates until the pistons are fully pushed back into the caliper.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
1 Ratchet mechanism
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
2 Pressure plate 3 Ratchet handle
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed