Publicité
Les langues disponibles
Les langues disponibles
Operation (continued)
2
Dispensing hot water
When dispensing water for the rst time from a new bottle,
press the hot water heating switch (K) on the back of the
dispenser. In approximately 14 minutes, the red light will
remain constantly "on." This indicates that hot water is
ready for dispensing. When the red light switches "off" the
hot water heating system is operational.
To dispense hot water, place a cup under the hot water
spigot. Then push the red child safety button (B) in followed
by the hot water button (C).
To prevent hot water from being dispensed accidentally
and possibly harming a child, the hot water dispensing
button can only be operated when the child resistant safety
lock (B) is pressed.
Upon releasing the hot water button (C), the child safety
lock (B) automatically returns to the locked position.
DANGER: The hot water is heated to approximately 194°F
/ 90°C. Temperatures above 125°F / 52°C can cause severe
burns from scalding. DO NOT ALLOW CHILDREN TO USE THE
HOT WATER DISPENSING BUTTON WITHOUT PROPER AND
DIRECT SUPERVISION.
K
J
B
C
Please contact 1-855-HD-GLACIER (1-855-434-5224) for further assistance.
3
Adjusting the cold water
temperature
NOTE: If the dispenser is not dispensing water, there
could be a possible ice build-up due to the thermostat
being set too cold. If this happens, unplug the
dispenser overnight and then reset. Set thermostat to
, slowly increasing based on your use and need for
cold water.
By turning the adjustable cold water thermostat (F) at the
back of the unit, (using a athead screwdriver) the
temperature can be adjusted. Turn the dial clockwise
between " " (cool) and "
desired temperature is reached.
NOTICE: ENERGY STAR FACTORY DEFAULT
SETTING: This model Water Dispenser left the factory with the
cold water temperature control factory "default setting" positioned
for "Energy Star" compliance (identi ed above). This setting will
deliver cold water temperatures between 4°C ~ 10°C (39°F ~
50°F) The cold water temperature can be adjusted, (using a at
screwdriver) by rotating the adjustment screw clockwise or anti-
clockwise between " " (cool) and "
temperature is reached.
NOTE: Any change/adjustment to the cold water
temperature control may affect Energy Star ef ciency.
7
" (colder) levels until the
F
" (colder) until the desired
HOMEDEPOT.COM/GLACIERBAY
Publicité
