Publicité
Les langues disponibles
Les langues disponibles
Pre-Installation (continued)
ANTI-LEAK BOTTLE SUPPORT COLLAR
The bottle support collar (A) on your water dispenser is engineered with a special anti-leak-proof system to prevent accidental loss of water,
( ooding) as a result of inadvertently installing a defective water bottle. Not all water bottles are created equal. Almost all 3 and 5 gallon (11
& 19 L) water bottles are recycled and handled extensively during cleaning, lling, and shipping. As a result, they are very prone to
developing hairline fractures and pinhole leaks that are not always obvious to the end user until the time of installation.
IMPORTANT: Never knowingly install a defective water bottle on a water dispenser. Return immediately for replacement.
Use these steps to determine whether your water bottle or dispenser is the source of any leaking:
Unplug the dispenser and remove the water bottle.
Remove the bottle support collar (A) and check the water level inside the reservoir. It should be roughly three quarters full.
Add or drain a few glasses of water to achieve the required ll level.
Closely monitor the water level inside the reservoir (1-2 hours). If the water level drops, immediately drain the remaining water
from the unit and call customer service at 1-855-HD-GLACIER (1-855-434-5224). If the water level remains constant, it is the water
bottle and not the dispenser that is leaking. Please contact your water supplier for a replacement bottle.
Operation
1
Dispensing cold water
Place a glass under the cold water spigot.
Press the cold water button (D).
A
6
3/4 FULL
D
Publicité
