Publicité
Les langues disponibles
Les langues disponibles
Pre-Installation (continued)
INITIAL CLEANING
1
2
6
7
Press both dispensing
Dispense water into cups
buttons.
and discard. Repeat until
no more water comes out.
11
12
8 Cups (2L)
Fresh Hot
Water
Flush with fresh
Repeat Steps 5 - 10.
hot water.
INSTALLING/REPLACING A WATER BOTTLE
IMPORTANT: Always wash your hands before installing a water bottle. Wipe the neck of the bottle with a clean cloth and do not
touch any portion of the dispenser that comes in contact with water.
Ensure the dispenser is unplugged.
Remove the protective cap from the end of the water bottle, unless the bottle has a puncturable cap or sticker.
Lift and turn the bottle upside down, placing it securely on the bottle support collar (A), and allow the dispenser to ll.
Press and hold both dispenser buttons (C and D) until water ows from the dispenser. Drain about 4 cups (1 L) of water before initial
use. This does not need to be repeated with replacement bottles.
Plug in the water dispenser.
Ready-to-dispense indicator lights (J) will come on when water reaches optimum temperature and is ready for use. In order to get
steaming hot water, the hot water heating switch (K) needs to be activated (see "Dispensing Hot Water").
3
4
Combine 6 Cups (1.5 L) Hot
Water with 2 Cups (0.5 L)
8
9
Place a bucket underneath
to catch the water.
Remove drain cap at the
back of the unit.
13
14
C
A
B
5
Please contact 1-855-HD-GLACIER (1-855-434-5224) for further assistance.
5
poured into the reservoir,
Vinegar.
wait 20 minutes.
10
Wait until water
Re-install drain cap and
stops flowing.
discard cleaning solution.
0
m
D
J
HOMEDEPOT.COM/GLACIERBAY
Publicité
