Qilive Q.6594 Manuel D'utilisation page 20

8. Adjust the tension of the door springs using an Allen key. Turn the key clockwise
EN
to tighten the springs on both the left and right sides of the door. Failure to do this
could cause damage to your dishwasher.
9. The dishwasher must be secured in place. There are two ways to do this:
a. Normal work surface: Put the installation hook into the slot of the side plane
and secure it to the work surface with wood screws.
b. Marble or granite work top: Fix the side with screws (see Fig. H).
Step 5. Levelling the dishwasher
The dishwasher must be level for proper rack operation and wash performance. (Fig.I)
1. Place a spirit level on the door and the rack track inside the tub, as shown, to
check that the dishwasher is level.
2. Level the dishwasher by adjusting the three levelling legs, individually.
Note: When levelling the dishwasher, do not let the dishwasher tip over.
Note: The maximum adjustment height of the feet is 50 mm.
6. USE
6.1. LOADING THE SALT INTO THE SOFTENER
■
■
( Fig. J)
■ Remove the lower basket. Unscrew the reservoir cap.
■ Place the end of the funnel into the hole. Pour in about 1.5 kg of dishwasher salt.
■ Fill the salt container to its maximum limit with water, It is normal for a small
amount of water to come out of the salt container.
■ After filling the container: Screw back the reservoir cap tightly.
■ The salt warning light will go off within 2-6 days after the salt container has been
filled with salt.
■ Immediately after filling the salt into the salt container, a washing program should
be started. Otherwise, parts of the appliance may be damaged by salty water.
1
2
Note: The salt container must only be refilled when the
control panel comes on. Depending on how well the salt dissolves, the salt
warning light may still be on even though the salt container is filled. If salt has
spilled, run a soak or quick program to remove it.
6.2. ADJUSTING SALT CONSUMPTION
The appliance is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Follow the steps below for adjustment in salt consumption.
Only use salt specifically designed for dishwashers use! Every
other type of salt not specifically designed for dishwasher use,
especially table salt, will damage the water softener. In case of
damages caused by the use of unsuitable salt the manufacturer does
not give any warranty nor is liable for any damages caused.
Only fill with salt before running a cycle. This will prevent any
grains of salt or salty water, which may have been spilled, remaining
on the bottom of the appliance for any period of time, which may
cause corrosion.
20
indicator in the