Publicité
Les langues disponibles
Les langues disponibles
in water to avoid the back flow of it.
■
Securely fix the drain hose in either position 1 or position 2.
Drain excess water from hoses: If the sink is 1000 mm higher from the floor, the
■
excess water in hoses cannot be drained directly into the sink. It will be necessary
to drain excess water from hoses into a bowl or suitable container that is held
outside and lower than the sink.
■
Water outlet: Connect the water drain hose. The drain hose must be correctly
fitted to avoid water leaks. Ensure that the water drain hose is not kinked or
squashed.
■
Extension hose: If you need a drain hose extension, make sure to use a similar
drain hose. It must be no longer than 4 metres; otherwise the cleaning effect of
the appliance could be reduced.
■
Syphon connection: The waste connection must be at a height less than
1000 mm from the bottom of the dish.
5.4. POSITION THE APPLIANCE
Built-In Installation (for the integrated model)
Step 1. Selecting the best location for the dishwasher (Fig.E)
The installation position of the dishwasher should be near an existing inlet and drain
hoses and power cord.
1.
Less than 5 mm between the top of the dishwasher and the cabinet with the
dishwasher door aligned to the cabinet.
2.
If the dishwasher is installed at the corner of the cabinet, there should be at least
50mm between the door and the cabinet when the dishwasher door is opened.
Note: Depending on where your electrical outlet is, you may need to cut a hole in the
opposite cabinet side.
Step 2. Aesthetic panel's dimensions and installation
Semi-integrated model
Magical paster A is found on the aesthetic wooden panel and magical paster B is on
the outer door of the dishwasher (see Fig.F, left). Unjoin the two magical pasters.
Position the panel and fix the panel to the outer door using screws and bolts (see Fig.F,
right).
Step 3. Tension adjustment of the door spring
1.
The door springs are factory set to the proper tension for the outer door. If you
install the aesthetic wooden panel, you will have to adjust the door spring tension.
Rotate the adjusting screw to tighten or loosen the steel cable (see Fig.G)
2.
The door tension is correct when the door remains horizontal when in the fully
opened position and rises with the slight lift of a finger.
Step 4. Dishwasher installation steps
1.
Affix the condensation strip under the work surface of the cabinet. Ensure the
condensation strip is flush with the edge of the work surface.
2.
Connect the inlet hose to the cold-water supply.
3.
Connect the drain hose.
4.
Connect the power cord.
5.
Position the dishwasher.
6.
Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the Philips screw in the middle of the base of the
dishwasher. To adjust the front feet, use a flat screw driver and turn the front feet
until the dishwasher is level.
7.
Install the furniture door to the outer door of the dishwasher.
19
EN
Publicité
