Tineco FLOOR ONE S2 Serie Mode D'emploi page 20

Troubleshooting
Problem
The appliance does not turn on
Weak suction
Brush roller tangled
indicator blinking
CWT empty indicator
blinking
All lights off in
operation
Battery level indicator
blinking
LED loop illuminates
red
Self-cleaning icon
blinking
Note:
If the above troubleshooting guide fails to provide a solution, please visit our website
www.tineco.com for further support.
Possible cause
Auto protection for overheating
The appliance has no power
The dry filter is not installed,
or the dry filter is dirty
Suction mouth is blocked
The brush roller is blocked
The brush roller is not
installed
CWT is empty
Battery overheat or malfunction
Low battery
Dirt sensor malfunction or
blocked
Brush roller is dirty
18
Solution
Restart after cooling down
Charge the appliance
Install the dry filter or clean and
allow it to dry completely
Pull up the brush roller and
remove blockages
Remove blockages
Install brush roller correctly
Refill CWT
Cool the appliance down and
restart
Charge the appliance, or restart
Remove blockages, clean the
debris channel, or restart
Start self-cleaning