Zanussi ZHC 600 Mode D'emploi page 15

www.elektromarkabolt.hu
○ ○ ○ ○ ○ ○ ○
Fitting the telescopic chimney stack (fig.8)
• To fit the upper section item S first expand the chimney slightly to allow it to fit over the
wall brackets (item 2) and then secure the upper section using the 4 screws supplied.
• The lower section item I of the chimney stack should be fitted between the lower bracket
2 and the wall. Fix the U-shaped section to the canopy, using two of the screws provided
in the bag of accessories.
• Chimney hood with grilles: once the chimney stack has been installed, fit the two venting
grilles into the apertures located on either side of the lower chimney section. The grilles
are to the wall the installer should ensure that the bottom edge is tucked down behind
the rear of the worktop marked with two arrows and should be fitted with one arrow
pointing upwards
recirculation mode ensure that the grilles are properly secured to the recirculation spigot
item R, as illustrated in fig.9.
GB
○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
and the other toward the front
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
. When the hood is used in the
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○
15
○ ○ ○ ○ ○