Xo C VISOR XOC24SC Mode D'emploi page 19

INSTALLATION OF THE HOOD ON THE LOWER PART OF THE WALL UNIT ONLY FOR 30".
This model includes side installation to the wall unit by using 2 brackets B (figure 3 besides
steps 3-4, indicated in figure 1 ).
1- Position template B on the wall unit, bearing in mind the measurements and the
minimum distance from the hob.
- Mark the references to fix brackets A to the wall unit, as indicated in figure 3 .
2 - Position the second template E on the side of the wall unit and make sure that the line
matches up with that traced in figure 3 - step 1.
3 - Mark and drill the 4 fixing holes (figure 3 - step 2).
- Fasten the 2 brackets G to the wall unit using the 4 screws D (figure 3 - step 3).
- Fasten the hood to bracket G using the 4 screws E (figure 3 - step 4-5).
4- Remove pin Y from bracket A. Then place the insert X on the slot of the bracket A, as
indicated in figure 1 - step 3.
- Match the C screws with the L wascher and fix the A bracket to the cabinet as indicated
in figure 1 - step 3.1. Pay attention not to completely tighten screws C before the bracket
firmly reaches the wall unit (figure 1 - step 3.2). After any adjusting, tighten the bracket
to the body (figure 1 - step 3.3).
- Fasten screw D to the wall unit as indicated in figure 1 - step 4.
- Once you have fastened the hood to the wall unit, adjust the spacer L, with screws P, to
make the device line up the rear wall unit (figure 1 - step 5).
IMPORTANT - The range hood must be secured to wall studs or use drywall
anchors capable of supporting 75 lbs.
E
G
E
5
4
- 19 -
30"