tomado TFT3001W Mode D'emploi page 12

Before using the fan for the first time, please proceed as follows: carefully unpack the appliance and all components and
remove all packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach
of children. After unpacking the appliance, check it for external damage that may have occurred during transport.
Assemble the fan in accordance with the instructions.
1. Start by placing the footplate at the foot of the fan. Tighten the wing nut [ a ] by a quarter turn to attach the footplate to the
foot.
2. Place the rear protective guard on the fan.
3. Fasten it by tightening the lock ring.
4. Insert the fan blade onto the fan. Test the fan blade by rotating it by hand. During rotation,
the blade should not create any friction with the lock ring. If it does, remove the fan and repeat all steps from the beginning.
5. Mount the fan blade with the fastening cap. Tighten the fastening cap by turning it to the left - counter-clockwise.
6. Place the front protective guard on the fan and use the clamps to attach it to the rear protective guard.
a. Align the front protective guard with the rear protective guard using the positioning clamp [ b ] on the
bottom side in order to attach both parts to each other properly. Use the bolt and nut at the top of the guards to fasten
the guards to each other.
b. Press the clamps [ c ] downwards in order to attach the front and rear protective guards to each other.
Place the fan on a flat, stable surface. Clean the exterior of the fan using a slightly damp cloth and then wipe it with a dry
cloth.
Protective guard - front
Fastening cap
6
a
ASSEMBLY
Fan blade Protective guard - rear
Lockring
5 4 3
bolt and nut
b
EN - 12
2
1
c
c
Motor
Foot
Footplate