Deltafox DG-CGS 3615 Traduction De La Notice D'utilisation Originale page 79

Do not dispose of the device
with the battery installed in
household waste, fire (risk of
explosion) or water. Damaged
batteries may damage the
environment and your health if
toxic fumes or liquids leak out.
• Dispose of the equipment with the
battery discharged. Do not open the
equipment or the battery.
• Dispose of the equipment in accord-
ance with the local regulations. Take
the equipment to a collection point,
where it will be recycled in an environ-
mentally friendly manner. For informa-
tion about this, ask your local waste
management company or our service
centre.
• Defective units returned to us will be
disposed of for free.
• Place cut branches in compost and
not in the dustbin.
Telescopic arm as an
accessory
Ensure that the safety key (
is removed before all tasks.
Caution! Device (80000667) is
delivered without a telescopic arm.
Alternatively, a telescopic arm
including wheels can be ordered
(see "Spare parts/accessories").
Assembling the telescopic arm
Putting the telescopic arm to-
gether:
1. Put both parts of the telescopic
arm (19) together and tighten
the screw.
Make sure that the cable is not
clamped.
Assembling/dismantling the
telescopic arm:
2. Push the device along the guide
rail (20) into the equipment
holder (21) of the telescopic
arm. It locks into place audibly.
3. Plug the plug connection (22)
into the charging socket (7) on
the back of the equipment han-
dle (6).
4. To dismantle, release the plug
connection (22). Press the un-
lock button on the bottom side
of the equipment holder (21) of
the telescopic arm and pull the
device out (see small image).
Adjust the height of the tel-
escopic arm
Adjust the length of the telescopic
arm for your size with the help of
the adjusting screw (23).
Adjusting the working angle
For a comfortable edge cut, the equip-
8) ment holder (21) of the telescopic arm can
be rotated to the right or left.
Set the desired position by pulling
the release switch (24) and rotat-
ing the equipment holder (21) of
the telescopic arm. The equipment
holder locks into the desired posi-
tion when the release switch is
released.
GB
79