KitchenAid KUDS01FL Guide D'utilisation Et D'entretien page 15

1. Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door to access the
control panel.
2. Press
Cancel glows.
3. Close the door. The dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely.
To stop the drain
You can press CANCEL again to stop the drain. Remember to
drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL before starting the dishwasher to clear all options
and cycles.
............ 0 EI_ + .......
During the first minute of a cycle
1. Open the door.
2. Press a new cycle and/or options.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
4. Close the door. The dishwasher resumes the new cycle
and/or option after a 5-second pause.
After the first minute of a cycle
1. Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door to access the
control panel.
2. Press
G.
Cancel glows.
3. Close the door. Your dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely.
4. Select a new cycle and/or options.
5. Press START.
6. Check the detergent dispensers. They must be filled properly
for the new cycle.
7. Close the door.
........... _11 ............................ +,, =
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Carefully open the door slightly to stop the cycle. Wait for the
spraying action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
01: I-]() t
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press Start to repeat the same cycle and options as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi-Temp Scrub
Select this option to heat the water during parts of the cycle, and
add a rinse. Higher water temperatures and an extra rinse helps
clean tough soils. Hi-Temp Scrub, with the Baked On Cookware
cycle, raises the water temperature in the prewash and main
wash. Hi-Temp Scrub, with the Normal cycle, raises the water
temperature in the main wash.
This option adds heat, water and wash time to a cycle.
NOTE: Hi-Temp Scrub is an option with the Baked On Cookware
and Normal cycles. Always use Hi-Temp Scrub if you have hard
water.
SANI RINSE
TM
Option
Select this option to raise the water temperature in the final rinse
to approximately 160°F (70°C). The SANI RINSE
TM
Option adds
heat and time to the cycle. This high temperature rinse sanitizes
your dishes and glassware in accordance with NSF/ANSI
Standard 184 for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food establishments.
NOTE: Baked On Cookware automatically uses this option. SANI
RINSE
TM
is an option with the Normal cycle. Only these
sanitization cycles have been designed to meet the NSF/ANSI
requirements.
ENERGY SAVER
TM
Dry System
Select this option to dry dishes without heat. ENERGY SAVER
TM
Dry System is useful if you do dishes at night and unload in the
morning.
-D_..22J
The dishes take longer to dry and some spotting can occur. For
best drying, always use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE: Rinse Only automatically uses this option. ENERGY
SAVER
TM
Dry System is an option with all other cycles.
Control Lock
Use Control Lock to prevent unintended use of the dishwasher.
You can also use the Control Lock feature to prevent unintended
cycle or option changes during a cycle.
O Control Lock
When Control Lock is lit, all buttons are disabled.
15