Solarjet SOL-M Manuel D'utilisation page 13

3 - INSTRUCTIONS FOR THE USER
5 - unscrew the brass
nut
Inspection and emptying shower
Mod. P3-P2
Internal inspection of the shower body can be carried
out through the cap placed in the lower part of the
shower.
E 'can proceed to the emptying in two different ways:

Method A:
•
disconnect the water connection
•
unscrew the inspection plug
•
tilt the shower

Method B:
•
disconnect the water connection
•
remove the reduction
•
rotate the handle of the mixer to the position "hot
water"
•
open the mixer
In this second case, after completion of all the
operations, make sure you have reassembled the
reduction previously removed.
Warnings
To ensure maximum efficiency of the solar shower (SOL
SN) report below some operations to be performed if
condensation occurring inside of the transparent tube
methacrylate:

empty the tank of the shower

completely unscrew and remove the cap of the air
vent (1) positioned at the end of the shower

leave the shower sun to a balanced condensation

fully screw the cap of the air vent valve

refill the tank of the shower with cold water
6 - remove the cartridge
Fig. 3.2-1
Fig. 3.2-1
IMPORTANT

If the feed water contains impurities, it is
essential to install a suitable filter.

For proper operation of MSN models:
•
P min: 2 bar
•
P max: 4 bar

For proper operation of the P3-P2-D:
•
Pmin: 1 bar
•
Pmax: 3 bar
3.3 CERTIFICATE OF CONVENTIONAL WARRANTY
The Solarjet product is guaranteed by the manufacturer
against manufacturing
according to the directives in force, to the exclusion of
natural alterations to the constant exposure to the sun.
The purchaser of the device may assert against th e
seller, the warranty for the duration of:

24 months from the date of delivery and / or
purchase, if the purchaser is a natural person acting
for purposes which are outside the scope of its
commercial and professional activities (Directive
99/44 / EEC and its implementing decree DL
February 2 2002, n. 24)

12 months from the date of delivery and / or
purchase, in all other cases not referred to in
paragraph 1 (art. 1591 cc)
The date of purchase must be mandatorily certified by a
tax document (receipt or invoice).
This standard warranty does not affect any rights under
the aforementioned Directive 99 / 44CEE and does not
exclude or limit the rights deriving from other legal
system standards of the country of use.
Also they excluded from the warranty deterior ation or
alteration of the product or its certain elements from
other causes, such as:
a) Incorrect installation (at maximum permitted water
pressure and water with no parameters allowed)
b) improper maintenance or lack thereof
c) tampering by unauthorized
qualified
d) use of the product with different purposes other
than those for which it was designed (use of
substance other than water)
e) due to major or catastrophic events (frost strength,
fire, floods, lightning, vandalism, etc ...)
f) transport and / or improper storage
g) any factor or alien phenomenon to the normal
conditions of use and operation of the appliance
(formation of scale or sludge, abnormal corrosion,
aggression or acidity of the water even if originating
from the same treatments, descaling o r cleaning
treatments carried out improperly)
h) use of spare parts, components and accessories
that are not original manufacturer
The warranty applies only to the original purchaser and
does not include fixture replacement.
Where the manufacturer try and recognize that the
product or one of its components has a defective
materials, in its sole discretion, will repair or replace it
for free. In both cases it will be given continuity to the
original warranty.
defects or material
persons and
flaws,
/ or