Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3 - INSTRUCTIONS FOR THE USER
3.1
RECOMMENDATIONS FOR YOU
Carefully read the instructions and warnings contained
in this booklet, as they provide important information
about safety, use and maintenance.
In case the appliance is sold or transferred to another
owner, ensure that this booklet accompanies the same,
so that they can be consulted by the new owner and / or
installer.
The device has been constructed for the delivery of
sanitary water: any other type of use is to be
considered as dangerous and unsuitable.
Incorrect installation can cause damage to people,
animals or property. The manufacturer declines all
responsibility in case of failure to follow instructions
given by him.
Do not place any kind on the subject.
The packaging components (plastic bags, polystyrene,
staples, ...) must not be left within reach of children and
must be disposed of according to current regulations in
the country of use.
It 'not tamper with any device calibrated and sealed at
the factory by the manufacturer.
IMPORTANT
SOL-S-N
During the winter period it is NECESSARY to
proceed to the emptying device leaving open the
safety valve
SOL M
During winter, NOT 'MUST proceed to drain the
water heater.
SOL-P3-P2-D
During
winter,
you
emptying device.
IMPORTANT
If you require prolonged periods
with temperatures below 0 ° C, it
is
protect
appropriate cover.
In the case where the solar shower remains exposed
to the sun for a long time without any levy, carefully
open the LEVER mixer keeping it facing downwards
to avoid the danger of burns or burns.
In the case where the solar shower remains exposed
to the sun WITHOUT WATER inside, it is absolutely
necessary
to
protect
TRANSPARENT and, in case it is present, raise the
lever of the safety valve and check valve.
In addition, in the case where the input is pre sent a
COLD WATER STOP COCK of the same, this must
never be closed. If, for whatever reason, there was
the need for having to close, leave at least MIXER
open and / or empty the shower.
MUST
proceed
to
advisable
to
temporarily
the
device
with
it
with
materials
IMPORTANT
Models P3-P2-D
Once opened, the mixer, the water will tak e
approximately 15-20 seconds before exiting from
the shower head as it will be necessary to wait
for the thrust of the pressure in the network
Once closed the mixer, the water will continue to
flow out of the shower head until it will not be
exhausted pushing previously induced by the
mains pressure (approximately 30 seconds).
3.2
MAINTENANCE EQUIPMENT
Clean shower
SOL-M-S-N
In the solar shower to accumulate the transparent tube
should be kept as clean as possible since the dust and
dirt restrict the absorption of solar rays decreasing the
yield.
For cleaning, it is sufficient to use water and neutral
soap (domestic use) with cloths not rough, to avoid
scratching the tube that would lose transparency. E
'absolutely
compounds, softeners or alcohol on the transparent
tube in methacrylate because it could damage.
Clean shower
SOL-D
For cleaning, it is sufficient to use specific products for
steel with cloths not rough, to avoid scratching the outer
surface of the tube.
the
Clean shower
SOL P3-P2
For cleaning, it is sufficient to use water and neutral
soap (domestic use) with cloths not rough, to avoid
scratching the outer surface of the tube.
an
IMPORTANT
The manufacturer disclaims all liability for damages
caused by the possible use of anti solvents, acids or
alcohol for cleaning the tube in methacrylate.
mixer cartridge
NOT
1 - mounted mixer
3 - remove the handle
forbidden
to
use
2 - loosen the screw of
the handle
4 - unscrew the ring
chromed cover-nut
solvents,
acetic
Publicité
Table des Matières
