Publicité
Les langues disponibles
Les langues disponibles
C
Problem
Unusual noises
Heavy build-up of
frost on the door
seal.
If the malfunction shows again, contact the Service Center.
Replacing the lamp
The switch of LED lamp is gravity controlled, when the angle
of the door-opening is bigger than 30 degrees, it will switch
on and off when the angle is smaller than 30 degrees.
• This product contains a light source of energy efficiency
class G.
• Light source in this product can only be replaced by
qualified professionals.
• Please contact after-sales service if the light source fails.
• The light source shall be removed at the end of the
product's useful life, with sorting and recycling done
separately.
Useful information
Possible cause
Appliance is not level.
The appliance is touching the
wall or other objects.
Acomponent, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Door seal is not air-tight.
16
Check the appliance and level it
by some articles.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Carefully warm the leaking
sections of the door seal with
a hair dryer (on a cool setting).
At the same time shape the
warmed door seal by hand such
that it sits correctly.
EN
Solution
Publicité
