Publicité
Les langues disponibles
Les langues disponibles
a) Insert interceptor into plow mount-leg up- as shown in diagrams. Insert pin
6
through mount and hole in interceptor and lock tab.
b) Hold push frame up in line with pair of holes on interceptor, that when
bolted, will hold push frame 6 to 8 inches above grade. NOTE: If lowest hole
pattern is too high, then it is okay to turn interceptor leg down.
c) Insert bolts, turn lock nuts on and tighten.
PUSH FRAME
60351
TETHER
CORD
HITCH PIN
10597
7
a) Hang blade assembly into
retainer grooves on push frame.
b) Insert keyhole pins into holes
on push frame.
c) Push set collar up against
receiver-hold and tighten set
screw (3/16" Allen wrench).
4
KEYHOLE
PIN 30489
BOLT 30512
1/2 X 4" BOLT WITH
LOCK NUTS
FLAT WASHER
WITH WASHERS
INTERCEPTOR
40650
BOLTS 1/2 X
LOCK NUT WITH
4" WITH FLAT
FLAT WASHER
WASHER
SET COLLAR
50616
MOUNT PUSH
FRAME BETWEEN
HAIR PIN
6" TO 8" ABOVE
GRADE
PUSH FRAME
Insert keyhole pin in hole, rotate pin just
enough to allow it through second hole and
rotate it back to its secure position.
KEYHOLE
PIN
Publicité
