Publicité
Les langues disponibles
Les langues disponibles
TOOLS NEEDED:
• Drill with 5/16" bit
• 9/16" socket w/ ratchet
• 3/4" box wrench (2)
• 7/16" wrench (1)
• Allen wrench 3/16"
• Protective eyewear
a) Each end of the rubber cutting edge has two factory marks (to
1
match with holes in skid bracket). Drill them out with 5/16" bit.
b) Mount skid bracket there. Tighten bolts until head sinks flush
with rubber surface. Repeat at other end.
TIP: When mounted-skid bracket should align flush
with or slightly above bottom of rubber.
a) Align groove on rubber with groove in
2
blade, so skid brackets face back to blade.
b) Slide rubber into channel in bottom of
blade and center it. (See Illustration in
Number 3).
NOTE: Rubber should be room
temperature before assembly
2
Note: Prior to plow assembly, park vehicle
on level grade. Measure clearance under
existing 2" rear receiver, for best results it
should be 8 to 16 inches above grade.
40795
1/4x 1
1/2 Bolt
RUBBER CUTTING
EDGE
FACTORY MARKED
HOLE LOCATIONS
LOCK WASHER
30623
NUT 30625
FLAT WASHER 90212
SKID BRACKET 40799
ALUMINUM
BLADE
SKID BRACKETS
FACE BACK SIDE OF
ALUMINUM BLADE
BACK SIDE
OF BLADE
Publicité
