Publicité
Les langues disponibles
Les langues disponibles
a) Locate factory marks on
3
back of blade. Place slide
hinge on blade and align both
lower holes with marks on
blade.
TIP: When mounted-slide hinges should measure about 14-1/2" apart.
a) Insert 2 square nuts in channel at end of blade and slide them over to line
4
up with holes at top of slide hinge.
b) Insert bolts through holes in slide hinge and thread onto nuts inside blade.
c) Make sure both lower holes in slide hinge are still in line with mark on
blade, then tighten 2 top bolts. Repeat at other end.
3/8" x 3/4" Bolt
10183
Washer
10185
5
a) First, with rubber centered on blade, use both lower holes in each slide
hinge as guide to drill 5/16" holes through first layer of aluminum and
partially into rubber. Then turn 3/8" thread cutting bolt into each hole and
tighten to secure each hinge.
b) Second, at factory mark
near each end of blade, drill
5/16" hole through first layer
of aluminum and partially into
rubber. Turn 3/8" thread cutting
bolt into hole and tighten.
FACTORY MARKS FOR HOLE
LOCATIONS ON BLADE
2 Square Nuts
Flat Side Up
10172
SLIDE HINGE
40743
These Holes in Hinge line up
W/Factory Marks on Blade (to
set hinges 14 ½" apart)
Slide Hinge
1st
2nd
3/8 x 1" Thread
Cutting Bolt
2nd
3
Publicité
