Ga.Ma GSE GC910 XPERT Manuel D'utilisation page 16

CAUTION:
Lubricate the blade before the first use. Read the instructions contained in the section "HOW AND WHEN TO
LUBRICATE THE BLADE"
USE INSTRUCTIONS:
• Insert the desired attachment. This operation should always be done with the hair clipper turned off.
·
Turn on the hair clipper by pressing the (O/I) button.
·
Turn off the hair clipper by pressing the (O/I) button.
INSERTION OF COMBS:
The supplied combs have two snap on seats. One near the
teeth of each comb (Fig.1) and the other near the base of
each comb (Fig.2). To insert the combs in the hair clipper,
set the snap on base near the teeth of the comb on the hair
clipper blade and then push the base of the comb against
the base of the blade head until you hear a slight click:
insertion will be now be completed. Remove the combs
using the tab located on the base of the comb, exerting an
outward force.
CUTTING LENGTH ADJUSTMENT:
GC910 XPERT can be used for trimming and finishing touches, when used without attachment comb and with the
blade regulator on the main body, which features the following lengths: from 0.8 to 3.8 mm. Otherwise, you can use
the four attachment combs supplied to achieve a classic hair cut to the following lengths: 3 mm, 6 mm, 10 mm and
13 mm.
CORD-CORDLESS FUNCTION:
This function makes it possible to use the hair clipper with and without the cord. If the appliance does not have
sufficient charge for use, it can be connected directly to the power supply without interrupting the cutting in
progress.
(Fig.1)
17
(Fig.2)