Troubleshooting
Error messages
F10
Overfilling water
F11
Water outlet fault
F12
Water inlet fault
F40
Inlet valve leakage
F41
Heater fault 1
F54
Overfilling water
F67
Water inlet fault
Press any button to clear the error message.
Problem
The control panel does not react
when pressed.
Cannot close door.
26
Action
Unblocking the drainage pump. See the chapter Care and cleaning.
If the problem persists, contact your nearest service centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Turn off the water tap and contact your nearest service centre.
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Possible causes
You have pressed the control
panel too soon after opening the
door.
The door is closed.
Dirt on the control panel.
The baskets are not correctly
positioned.
The door lock does not click in-
to place and lock.
Action
Wait a moment then try again.
Open the door. The control
panel only reacts to use when
the door is open.
Clean with a dry or slightly
damp cloth.
Check that the baskets are cor-
rectly positioned horizontally.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.
Check the door lock. If it does
not click into place and lock,
open the door.