Pelgrim GVW230LS/P05 Manuel D'utilisation page 138

Stopping or changing a program
Open the door. If you want to interrupt or change the program after starting the dishwasher, press
and hold for three seconds.
Top up with new detergent if the lid of the detergent dispenser has opened. Then select a new program,
press and close the door.
Remaining time
Once you have chosen a program and options, the time the program took when last used is displayed.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a while,
the dishwasher continues the program.
Power failure
If the dishwasher is turned off due to a power failure when a dishwashing program is running, the
program continues when power is restored. If the power is cut during drying, the program is interrupted.
If you open the door for more than 2 minutes during drying, the program will be interrupted.
Once the program has finished
The end of the program is indicated by one short signal from the buzzer. The chapter Settings describes
how to change this function.
Once the dishwasher door is opened and the program has finished "End" appears on the display.
The dishwasher switches off automatically after the program ends. Shut off the water tap after each
use (if required by your insurance company).
The best drying results
Fully load the dishwasher.
Angle dishes with hollows, such as cups, so that the rinse water will run off. This is also important
for plastic items.
Top up with rinse aid or increase the rinse aid dosage setting.
Activate the Automatic door opening setting. See the chapter Settings.
Allow the dishes to cool before unloading the dishwasher.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from the upper basket falling onto the dishes
in the lower basket.
1)
You should not load more dishes if the lid of the detergent dispenser has been opened.
18
1)