Télécharger Imprimer la page

Bertazzoni La Germania MG Serie Notice D'installation, D'entretien Et Mode D'emploi page 31

Publicité

Les langues disponibles

Les langues disponibles

Cleaning the inside of the oven glass:
One of the features of the oven is the possibility of removing the interior glass simply by loosening the 2 screws B (fig.
44-45), to clean the inside surface of the glass. This operation should be carried out while the oven is cold and with a
damp cloth. Do not use abrasives.
Cleaning the inside of the oven:
To thoroughly clean the inside of the oven, it is recommended to disassemble the door by carefully following the
instructions described below. Insert the hook C (figure 46) into the hinged sector D . Put the door in a semi-open position
and using both hands pull it towards you until it is released from the attachment. To replace the door, do the opposite
making sure to insert the two sectors F correctly. In addition, the side shelves can be removed very easily, by loosening
the lock rings that attach them to the oven.
Oven door with glass stuck:
Cleaning the inside of the oven glass:
Cleaning the interior of the crystals of the oven:
Feature of the oven is the ability to remove the inner glass in order to make the internal cleanliness of crystals. This
operation is to be performed in a cold oven and with a damp cloth, taking care not to use abrasive detergents. For the
removal of internal glass lock the hinges by inserting the nail that came in the hinges (22 Fig 47-48) then remove the
inner glass as (Fig.49-50-51-52-53-54)..
To reassemble the door to perform tasks in the opposite direction as (fig.55-56-57-58).
Cleaning the inside of the oven:
To facilitate intensive cleaning of the oven is practical to dismantle the door by following the instructions listed below.
Insert the nail that came in the hinges (Fig. 47-48). Bring the half-open door in place and working with your hands pull the
door towards you until the same has not been dropped from the attack. To replace the oven door proceed in reverse
order. Also the grids side are easily-removable by unscrewing the rings that secure it to the oven.
AFTER-SALES TECHNICAL SERVICE AND SPARE PARTS
Before leaving the factory, this appliance was tested and calibrated by skilled and qualified personnel.
Any repairs or calibration that may become necessary after leaving the factory should be performed by skilled personnel.
For this reason we advise the customer to contact the Dealer that sold the appliance or the nearest Service Centre,
providing them with information about the type of appliance and the type of problem that has occurred.
If defective parts must be replaced, it is recommended to replace them with original spare parts that are available only in
our technical Service Centres and authorised dealers.
31

Publicité

loading

Ce manuel est également adapté pour:

La germania mgv serieLa germania amn805gevswe