Frigelux CUBECV40A++ Manuel D'utilisation page 31

▪ Leveling
Make sure the appliance is level. Use the adjustable feet at the front. If the appliance is not
level, the doors and magnetic sealing alignments will be affected and may cause
malfunctions.
▪ Do not turn on the appliance for 4 hours
After any movement, it must not be connected for 4 hours. This delay allows the coolant to
be adjusted.
▪ Installation
Let your device breathe. Heat is released from the walls so it is important to leave a
circulation of air around your device.
Using your ice cube tray
▪
Recommended thermostat setting for ice making is position MAX of freezer section.
▪
Fill the ice cube tray (two thirds of it) with cold water or with any liquid suitable for
freezing and place the tray on the bottom of the unit to freeze properly.
▪
Dry the tray, otherwise it may stick to the bottom of the unit.
▪
The best method to get ice cubes out of the tray is to hold the tray under cold tap
water for a second.
▪
To eject the ice cubes from the tray, place over the ice bucket and twist slightly.
Reversible door
The side to which the refrigerator door opens can be altered on the right side to the left, if
the place of installation so requires.
Ensure the appliance is unplugged and empty before starting.
CAUTION: Two people are required to carry this out to avoid possible damage or injury.
1. Keep the glass door closed during removal and fitting of the hinges.
2. Remove the plastic rivet (1) and top hinge cover (2) on the right side gently with a
screwdriver to expose the fixing screws.
3. Remove the top hinge screws (3) and the hinge bracket (4) on the right side (remember
to hold the glass door in place when undoing these screws).
4. Remove the glass door, then remove the plastic plug (5), and place safely aside.
5. Carefully lean the chiller backwards to an angle of approximately 60° to allow access to
the bottom hinge screws and feet. Ensure the appliance will not slip or move.
6. Remove the bottom hinge screws (7) and hinge bracket (6) on the right side.
7. Remove top hinge cover (2) and bottom foot (8) on the left side.
8. Fit top hinge cover (2) and bottom foot (8) on the right side.
9. Fit bottom hinge bracket (6) on the left side.
10. Carefully bring chiller back to the upright position.
11. Place glass door onto bottom hinge bracket and hold in place.
12. Fit top hinge bracket (4) on the left side, carefully checking the door alignment.
13. Fit top hinge cover (2) on the left side.
31