Hitachi RAK-35RPC Manuel D'instructions page 19

LEAVE HOME (LH) OPERATION
Prevent the room temperature from falling too much when no one is at home. The initial setting temperature is 10°C and the
temperature range can be set between 10°C and 16°C.
This operation is able to operate by "Continuous operation" or "Day timer operation". Please use "Day timer operation" to
set the number of days up to 99 days.
Continuous operation
2
1
Day timer operation
2
1
3
4
NOTE
●
After reaching the set number of operation days for Leave Home or by pressing the (Leave Home) button again,
the unit will operate in previous mode.
●
During Leave Home operation, fan speed and horizontal air defl ector position cannot be changed.
●
By pressing (Leave Home) button, implementation of Weekly Timer or Once Timer is cancelled.
●
In case of power supply shut down, after autorestart, all setting for number of days operation will be reset and unit
shall be in continuous operation.
●
POWERFUL, SILENT and ECO operations are not applicable during Leave Home operation.
●
For multi connection
FAN/COOLING/DEHUMIDIFYING and Leave Home cannot operate at the same time.
●
The fi rst-run unit has a priority and other units in different mode will be in standby mode.
Heating operation can be used with Leave Home.
●
When two or more rooms are set to operate Leave Home, the temperature set by Leave Home may not be
●
reached. It also depends on outdoor temperature.
■ To start LEAVE HOME operation
Option 1. Continuous operation.
1
Press (LEAVE HOME) button during stop or operation.
Room temperature is set at 10°C and heating operation starts.
2
Set the desired room temperature with the TEMPERATURE buttons.
Temperature range can be set between 10°C and 16°C.
" ", " ", "
on the LCD.
Option 2. Day timer operation.
Press (LEAVE HOME) button during stop or operation.
Room temperature is set at 10°C and heating operation starts.
Set the desired room temperature with the TEMPERATURE buttons.
Temperature range can be set between 10°C and 16°C.
" ", " ", "
on the LCD.
3
Set number of operation days (1 to 99 days), if needed.
Press (TIME) button to select number of days.
Number of days blink.
* Press " (UP)" or "
1 day to 99 days.
* Number of day is counted when clock indicates 0:00.
4
Press (SEND) button to confi rm number of operation days.
Display for number of operation days will stop blinking.
Press (CANCEL) button to reset number of operation days
or to have continuous operation.
To cancel LEAVE HOME operation
●
Press (START/STOP) button. Or
●
Press (LEAVE HOME) button again.
Return to previous operation mode. Or
●
Change to other operation mode by pressing
– 15 –
", " ", "SET TEMPERATURE" is displayed
", " ", "SET TEMPERATURE" is displayed
(DOWN)" to set number of days from
(MODE) button.